Oblivion Bubble Ship |
By Paul Taylor |
This model is a one-off build and not a kit, which I scratch built and looks stunning on display. It is lighted using tiny SMD LEDs with one inside the cockpit upper ring and one each side of the ball-shaped engine pods. It has a black wooden base with a glass top stand that has the TET emblem on it. The model is approximately 10 inches long x 9.5 inches wide. I am not sure of the scale but would say approx. 1/32. It is powered by a supplied 9-volt battery from the underside of the base which also has an on/off rocker switch. The ball-shaped engine pods can rotate into desired position; the cockpit and guns do not rotate. The model has a 2.1mm x 5mm connector on the underside with cables that loosely run to the rear side of the base. These cables have Bullet Banana Gold Plated Connector Plugs that push into connectors on the base. Image: Base Image: Cockpit Image: Front Left Image: Front Top Image: Rear Image: Rear left Image: Rear Right |
Starship Modeler Home | Site Map | Gallery Main Page | Feedback
This page made possible by Starship Modeler - copyright © 2011.